FatTwin F627R3-RTB+/R72B+ User's Manual
6-5
Installing and Removing Hard Drives
The SCF424AS chassis contains individual motherboards in separate 2U nodes.
Each motherboard node controls the hard drives contained within that node. Note
that if a motherboard node is pulled out of the chassis, the hard drives associated
with that node will power down as well. Refer to the charts below and on the
following pages for your specifi c chassis confi guration. These instructions apply to
hot-swappable hard drives in both 2.5" and 3.5" sizes. Hot-swappable hard drives
can be removed from the chassis without powering down the server or removing
the node from the chassis.
Only enterprise level hard drives are recommended for use in Supermicro chassis.
Node 2
Controls six front 3.5" HDDs, B1-B6
and two rear 3.5" HDDs B7-B8
Node 1
Controls six front 3.5" HDDs, A1-A6
and two rear 3.5" HDDs A7-A8
Figure 6-2: Hard Drives and the Corresponding Motherboards
(Your chassis and drives may differ from the one shown in this illustration)
Node Locations in the Chassis
6-4
Node 4
Controls six front 3.5" HDDs, D1-D6
and two rear 3.5" HDDs D7-D8
Node 3
Controls six front 3.5" HDDs, C1-C6
and two rear 3.5" HDDs C7-C8