Installing The Vertical Stabilizer - Seagull Models ZERO MS:123 Assembly Manual

ZERO.
10) After the epoxy has fully cured, re-
move the masking tape or T-pins used to hold
the stabilizer in place. Carefully inspect the
glue joints. Use more epoxy to fill in any gaps
that may exist that were not filled previously
and clean up the excess using a paper towel
and rubbing alcohol.

INSTALLING THE VERTICAL STABILIZER.

1) Using a modeling knife, remove the
covering from over the precut hinge slot cut
into the lower rear portion of the fuselage.
26
Fill epoxy.
Remove covering.
Instruction Manual.
2) While holding the vertical stabilizer
firmly in place, use a pen and draw a line on
each side of the vertical stabilizer where it
meets the top of the fuselage.
3) Slide the v ertical stabilizer back in
place. Using a triangle, check to ensure that
the vertical stabilizer is aligned 90º to the hori-
zontal stabilizer.
Horizontal
90º
Stabilizer.
Fill epoxy.
Fill epoxy.
Vertical
Stabilizer.