Installing The Fuselage Ser Vos - Seagull Models ZERO MS:123 Assembly Manual

8) Use plywood template to hold in place
the fuel tank with C/A glue to secure the fuel
tank i nside t he f uselage.
Epoxy.
Plywood template.
Fuel pick up tube.
9) Connect the lines from the tank to the engine
and muf fler. The vent line will connect to the
muffler and the line from the clunk to the
carburetor.
www.seagullmodels.com
Fuel tank.
sure the fuel lines have not become kinked
inside the fuel tank compartment.
should flow through easily.
Fuel tank.
may need to adjust the size of the precut open-
ing in the mount. The notch in the sides of the
mount allow the servo lead to pass through.
collets onto the throttle servo. Test fit the servo
into the aileron servo mount.
vided with your radio system.
Vent tube.
Fuel fill tube.
Blow through one of the lines to en-

INSTALLING THE FUSELAGE SER VOS.

Because the size of servos differ, you
1) Install the rubber grommets and brass
2) Secure the servos with the screws pro-
Rudder servo.
Elevator servo.
Air
Throttle servo.
9