7.
Fill Epoxy
8.
INSTALLING THE VERTICAL
STABILIZER
1.
Using a modeling knife, remove the cover-
ing from over the precut hinge slot cut into
the lower rear portion of the fuselage.
2.
3.
While holding the vertical stabilizer irmly
in place, use a pen and draw a line on each
side of the vertical stabilizer where it meets
the top of the fuselage.
4.
Slide the vertical stabilizer back in place.
Using a triangle, check to ensure that the ver-
tical stabilizer is aligned 90º to the horizontal
stabilizer.
5.
6.
Fill Epoxy
29