Configuring The Ip Address For An Interface - HP A-F1000-E Getting Started Manual

Item
HTTPS

Configuring the IP address for an interface

Click Next on the service management configuration page to enter the interface IP address configuration
page, as shown in
Ethernet interfaces and VLAN interfaces. You can click a value in the table and then modify it.
Figure 55 Basic configuration wizard: 4/6 (interface IP address configuration)
Description
Specify whether to enable HTTPS on the device, and set the HTTPS port number.
Disabled by default.
IMPORTANT:
•
If the current user logged in to the web interface through HTTPS, disabling HTTPS
or modifying the HTTPS port number will result in disconnection with the device;
therefore, perform the operation with caution.
•
When you modify a port number, ensure that the port number is not used by
another service.
•
By default, HTTPS uses the PKI domain default. If this PKI domain does not exist, the
system will prompt you for it when the configuration wizard is completed; however,
this will not affect the execution of other configurations.
Figure 55. The table lists the IP address configuration information for all Layer 3
83