Basic Configuration; Launching The Basic Configuration Wizard - HP A-F1000-E Getting Started Manual

Basic configuration

You can perform the following basic configuration in the web or at the CLI:
System name and user password. Modify the system name and the password of the current user. For
•
more information, see the chapters "Device management configuration" and "User management."
Service management. Specify whether to enable the services like FTP, telnet, HTTP, and HTTPS, and
•
set port numbers for HTTP and HTTPS. For more information, see Access Control Configuration
Guide.
Interface IP address. Configure IP addresses for Layer 3 Ethernet interfaces and VLAN interfaces.
•
For more information, see Network Management Configuration Guide.
NAT. Configure dynamic NAT, internal server translation, and related parameters. For more
•
information, see NAT Configuration Guide.
Zone. Configure a zone to perform interface- or IP address-based security policy control. For more
•
information, see Access Control Configuration Guide.
This chapter describes the fast configuration by using the basic configuration wizard.

Launching the basic configuration wizard

Select Wizard from the navigation tree to enter the Configuration Wizard page, and then click the Basic
Device Information hyperlink to enter the first page of the basic configuration page, as shown in
52.
79
Figure