HP A-F1000-E Getting Started Manual page 108

Configuring a scheduled task—approach 1
Follow these steps to configure a scheduled task:
To do...
Specify a command to be
executed at the specified time
Specify a command to be
executed after the specified
delay
Configuring a scheduled task—approach 2
Follow these steps to configure a scheduled task:
To do...
Enter system view
Create a scheduled task
and enter job view
Specify the view in which
the task is executed
Configure a command to
be executed at a specific
time
Configure a command to
be executed after a delay
time
NOTE:
Only one view can be specified for a task, which means all commands in the task are executed in the
•
same specified view. If different views are specified by executing the view
repeatedly, only the last configuration takes effect.
• The view must be supported by the system, and the view name must be complete instead of an
abbreviation. Most commonly used view names include: monitor for user view, system for system view,
GigabitEthernetx/x for Ethernet interface view, and Vlan-interfacex for VLAN interface view.
A scheduled task can contain up to 10 commands. If you want more than 10 commands to be executed,
•
configure them in different tasks.
time-id
A
•
the same, the one configured later is effective.
Use the command...
schedule job at time
[ date ] view view
command
schedule job delay time
view view command
Use the command...
system-view
job job-name
view view-name
time time-id at time date command
command
time time-id { one-off | repeating } at
time [ month-date month-day |
week-day week-daylist ] command
command
time time-id { one-off | repeating }
delay time command command
uniquely identifies the binding between a command and its execution time. If two time-ids are
Remarks
Required
Use either command
Available in user view
•
If you use the schedule job at command,
changing the system time will change the
execution time of the scheduled task.
•
If you use the schedule job delay command,
changing the system time will not change the
execution time of the scheduled task.
Remarks
—
Required
Required
You can specify only one view for a task.
Required
Use any of the commands.
•
•
102
If you use the time at command,
changing the system time will change
the execution time of the scheduled
task.
If you use the time delay command,
changing the system time will not
change the execution time of the
scheduled task.
view-name
command