Logging in to the firewall module from the
network device
NOTE:
This chapter describes how to log in to the firewall module from the network device. Other login methods
for the firewall module are the same as a firewall. For more information, see the previous chapters.
Logging in to the firewall module from the network
device
Configuring the AUX user interface of the firewall module
Before logging in to the firewall module from the network device, you need to configure the AUX user
interface of the firewall module.
Follow these steps to configure the AUX user interface:
To do...
Enter system view
Enter AUX user interface view
Specify the none authentication
mode
Configure the user privilege level
Logging in to the firewall module
Use the following command to log in to the firewall module. After login, the terminal screen displays the
CLI of the firewall module. To return to the CLI on the device, press Ctrl+K.
Follow the step below to log in from the network device to the firewall module:
To do...
Log in from the network device to
the firewall module
Use the command...
system-view
user-interface aux first-number
[ last-number ]
authentication-mode none
user privilege level level
Use the command...
oap connect slot slot-number
73
Remarks
—
—
Required
By default, the AUX user interface
uses password authentication.
Required
0 by default. HP recommends you
to set it to 3.
Remarks
Required
Available in user view of the network
device (switch or router)