On the PC, launch the browser, type the IP address 192.168.0.1 in the address bar, and press
3.
Enter to enter the web login page, as shown in
and the verification code, select a language (English), and click Login.
Figure 41 Web login page
CAUTION:
To get a new verification code, click on the verification code picture.
•
Up to five users can concurrently log in to the device through the web interface.
•
Modifying the default web login information
Log in to the firewall, and configure as follows:
Create a Telnet user, set the username to userA, password to 123456, and user privilege level to
1.
3.
[HP] local-user userA
New local user added.
[HP-luser-userA] servce-type telnet
[HP-luser-userA] password simple 123456
[HP-luser-userA] authorization-attribute level 3
Add an interface into the management zone in hidden command line view to enable the firewall
2.
to communicate with a PC through this interface, and then you can log in to the firewall through this
interface.
[HP]_
Now you enter a hidden command view for developer's testing, some commands may
affect operation by wrong use, please carefully use it with our engineer's
direction.
[HP-hidecmd] zone add interface GigabitEthernet0/1 to management
Configuring the web login function
If the web function is disabled, log in to the device via the console port, and perform the following
configuration:
Enable HTTP or HTTPS service
•
Configure the IP address of the management Ethernet interface
•
•
Configure a username and password
The device supports the following web login methods:
Figure
41. Enter username admin, password admin,
58