HP A-F1000-E Getting Started Manual page 46

To do...
Define a shortcut key
for starting a session
Define a shortcut key
for terminating tasks
Configure the flow
control mode
Configure the type of
terminal display
Configure the user
privilege level for
login users
Set the maximum
number of lines on
the next screen
Set the size of history
command buffer
Set the idle-timeout
timer.
CAUTION:
The common settings configured for AUX login take effect immediately. If you configure the common
settings after you log in through the AUX port, the current connection may be interrupted, so you should
use another login method. After you configure common settings for AUX login, you need to modify the
settings on the terminal to make them consistent with those on the device.
Use the command...
activation-key
character
escape-key { default |
character }
flow-control
{ hardware | none |
software }
terminal type { ansi |
vt100 }
user privilege level
level
screen-length
screen-length
history-command
max-size value
idle-timeout minutes
[ seconds ]
40
Remarks
Optional
By default, you can press Enter to start a
session.
Optional
By default, you can press Ctrl+C to terminate
a task.
Optional
Optional
By default, the terminal display type is ANSI.
The device supports two types of terminal
display: ANSI and VT100. HP recommends
you to set the display type of both the device
and the client to VT100. If the device and the
client use different display types (for example,
hyper terminal or Telnet terminal) or both are
set to ANSI, when the total number of
characters of the currently edited command
line exceeds 80, an anomaly such as cursor
corruption or abnormal display of the
terminal display may occur on the client.
Optional
By default, the default command level is 0 for
the AUX user interface.
Optional
By default, the next screen displays 24 lines
at most.
A value of 0 disables the function.
Optional
By default, the buffer saves 10 history
commands at most.
Optional
The default idle-timeout is 10 minutes. The
system automatically terminates the user's
connection if there is no information
interaction between the device and the user in
timeout time.
Setting idle-timeout to 0 disables the timer.