Modifying The Level Of A Command; Saving The Current Configuration; Displaying And Maintaining Cli - HP A-F1000-E Getting Started Manual

Modifying the level of a command

All the commands in a view default to different levels. The administrator can change the default level of
a command to a lower level or a higher level as needed.
Follow these steps to modify the command level:
To do...
Enter system view
Configure the command level in a
specified view
CAUTION:
HP recommends you to use the default command level or modify the command level under the guidance
of professional staff. An improper change of the command level may bring inconvenience to your
maintenance and operation, or even potential security problems.

Saving the current configuration

On the device, you can input the save command in any view to save all the submitted and executed
commands into the configuration file. Commands saved in the configuration file can survive a reboot.
The save command does not take effect on one-time commands, such as display commands, which
display specified information, and the reset commands, which clear specified information. The one-time
commands executed are never saved.

Displaying and maintaining CLI

To do...
Display defined command aliases
and the corresponding commands
Display the clipboard information
Use the command...
system-view
command-privilege level level view
view command
Use the command...
display command-alias
display clipboard
134
Remarks
—
Required
See Table 16 for the default
settings.
Remarks
Available in any view
Available in any view