HP A-F1000-E Getting Started Manual page 44

To do...
Enter the default
ISP domain view
Configure
Apply the
the
specified AAA
authentica
scheme to the
tion mode
domain
Exit to system
view
Create a local user and enter
local user view
Set the authentication
password for the local user
Specifies the command level
of the local user
Specify the service type for
the local user
Configure common settings
for AUX login
After you enable command authorization or command accounting, you need to perform the following
configuration to make the function take effect:
• Create a HWTACACS scheme, and specify the IP address of the authorization server and other
authorization parameters.
Reference the created HWTACACS scheme in the ISP domain.
•
When users adopt the scheme mode to log in to the device, the level of the commands that the users can
access depends on the user privilege level defined in the AAA scheme.
When the AAA scheme is local, the user privilege level is defined by the authorization-attribute
•
level level command.
• When the AAA scheme is RADIUS or HWTACACS, the user privilege level is configured on the
RADIUS or HWTACACS server.
After the configuration, when you log in to the device through the AUX port, you are prompted to enter
a login password. A prompt such as <HP> appears after you input the password and press Enter, as
shown in Figure 27.
Use the command...
domain domain-name
authentication default
{ hwtacacs-scheme
hwtacacs-scheme-name
[ local ] | local | none |
radius-scheme
radius-scheme-name
[ local ] }
quit
local-user user-name
password { cipher |
simple } password
authorization-attribute
level level
service-type terminal
—
38
Remarks
Optional
By default, the AAA scheme is local.
Required
By default, no local user exists.
Required
Optional
By default, the command level is 0.
Required
By default, no service type is specified.
Optional
See "Configuring common settings for AUX
login (optional)."