HP A-F1000-E Getting Started Manual page 55

When you log in to the device through modems, specify operating mode of the AUX interface is protocol.
Configuration procedure
Follow these steps to configure none authentication for modem login:
To do...
Enter system view
Enter AUX interface view
Specify operating mode for the
AUX interface
Exit to system view
Enter one or more AUX user
interface views
Specify the none authentication
mode
Configure common settings for VTY
user interfaces
After the configuration, when you log in to the device through modems, you are prompted to press Enter.
A prompt such as <HP> appears after you press Enter, as shown in
Figure 38 Configuration page
Use the command...
system-view
interface aux interface-number
async mode { flow | protocol }
quit
user-interface aux first-number
[ last-number ]
authentication-mode none
—
49
Remarks
—
—
Required
By default, the mode is flow.
—
—
Required
By default, the modem login
authentication mode is password.
Optional
See "Configuring common settings
for VTY user interfaces
Figure 38.
(optional)."