HP A-F1000-E Getting Started Manual page 34

To do...
Enable the terminal
service
Enable the current
user interface(s) to
support either Telnet,
SSH, or both of them
Define a shortcut key
for terminating tasks
Configure the type of
terminal display
Set the maximum
number of lines on the
next screen
Set the size of history
command buffer
User
interface
configuration
Set the idle-timeout
timer
Specify a command
to be automatically
executed when a user
logs in to the current
user interface
CAUTION:
The auto-execute command command may disable you from configuring the system through the user
interface to which the command is applied. Before configuring the command and saving the configuration
(by using the save command), make sure that you can access the device through VTY, TTY, console, or
AUX interfaces to remove the configuration when a problem occurs.
Use the command...
shell
protocol inbound { all
| ssh | telnet }
escape-key { default |
character }
terminal type { ansi |
vt100 }
screen-length
screen-length
history-command
max-size value
idle-timeout minutes
[ seconds ]
auto-execute
command command
28
Remarks
Optional
Enabled by default.
Optional
By default, both protocols are supported.
The configuration takes effect next time you
log in.
Optional
By default, you can press Ctrl+C to terminate
a task.
Optional
By default, the terminal display type is
ANSI.
Optional
By default, the next screen displays 24 lines.
A value of 0 disables the function.
Optional
By default, the buffer saves 10 history
commands.
Optional
The default idle-timeout is 10 minutes for all
user interfaces.
The system automatically terminates the
user's connection if there is no information
interaction between the device and the user
in timeout time.
Setting idle-timeout to 0 disables the timer.
Optional
By default, command auto-execution is
disabled.
The system automatically executes the
specified command when a user logs in to
the user interface, and tears down the user
connection after the command is executed.
If the command triggers another task, the
system does not tear down the user
connection until the task is completed. A
telnet command is usually specified to
enable the user to automatically telnet to the
specified device.