Configuring Password Authentication For Modem Login - HP A-F1000-E Getting Started Manual

Configuring password authentication for modem login

Configuration prerequisites
You have logged in to the device.
By default, you can log in to the device through the console port without authentication and have user
privilege level 3 after login. For information about logging in to the device with the default configuration,
see "Configuration
When you log in to the device through modems, specify operating mode of the AUX interface is protocol.
Configuration procedure
Follow these steps to configure password authentication for modem login:
To do...
Enter system view
Enter AUX interface view
Specify operating mode for
the AUX interface
Exit to system view
Enter one or more AUX
user interface views
Specify the password
authentication mode
Set the local password
Configure common settings
for VTY user interfaces
After the configuration, when you log in to the device through modems, you are prompted to enter a
login password. A prompt such as <HP> appears after you input the password and press Enter, as shown
in Figure 39.
requirements."
Use the command...
system-view
interface aux interface-number
async mode { flow | protocol }
quit
user-interface aux first-number
[ last-number ]
authentication-mode password
set authentication password
{ cipher | simple } password
—
Remarks
—
—
Required
By default, the mode is flow.
—
—
Required
By default, the modem login authentication
mode is password.
Required
By default, no local password is set.
Optional
For more information, see
common settings for VTY user interfaces
(optional)."
50
"Configuring