Sony STR-ZA3100ES Help Manual page 183

Help Guide
MULTI CHANNEL AV RECEIVER
STR-ZA3100ES/STR-ZA2100ES/STR-ZA1100ES
2. Before you perform Auto Calibration
Before you perform Auto Calibration, check the following items:
Set up and connect the speakers.
Do not connect any microphones other than the supplied calibration microphone to the CALIBRATION MIC jack.
If using a bi-amplifier connection or speakers with a front B connection, set the assignment for the SPEAKERS
SURROUND BACK/HEIGHT (FRONT B/BI-AMP/ZONE 2) terminals properly. For details, see
surround back speaker terminals (SB Speaker
Set the speaker output to a setting other than [SPEAKERS OFF]. For details, see
Remove any obstructions between the calibration microphone and the speakers.
For accurate measurement, make sure the environment is quiet and free from noise.
Note
The speakers emit very loud sound during the calibration and the volume cannot be adjusted. Be considerate of your neighbors
and any children who are present.
If the muting function has been activated before you perform Auto Calibration, the muting function will shut off automatically.
It may not be possible to take the correct measurements or to perform Auto Calibration at all if special speakers such as dipole
speakers are used.
Related Topic
4. Selecting the front speakers
3. Connecting the calibration microphone
Confirming active subwoofer setup
Selecting the speaker pattern (Speaker Pattern)
Assigning the surround back speaker terminals (SB Speaker Assign)
Assign)."
4-686-529-11(5) Copyright 2017 Sony Corporation
183
"Assigning the
"4. Selecting the front speakers."