Output Setting; Operation; Normal Operation; Default Setting - IDTECK ITDC ITDCSR EIO88 User Manual

Hide thumbs Also See for ITDC ITDCSR EIO88:

Table of Contents

IDTeck – iTDC 2~4 DOOR ACCESS CONTROLLER

4. RA__RB__RC__RD__: RA, RB, RC and RD are Reader Usage codes for the cardholder. If you put '1'

for RA then Reader #1 is accessible and if you put '0' for RA then the cardholder can not access through

the Reader #1 and iTDC generates an error message "Access Door Error" and displays on the LCD. To

get access through all 4 Readers, you have to input '1' value for RA, RB, RC and RD.

8.7 OUTPUT SETTING

You can program the output behaviour by using the application software. Please refer to APPENDIX for

factory settings.

Power on

When the power is applied to iTDC, the LED7 is turned on.

Registered card reading

When a registered card (or PIN) is read, the Door (Relay #1, Relay #3) will open for 3 seconds (Default)

with the LED on. (LED8, LED10)

Exit Button

To request for exit from the inside, an Exit Button (or an Exit Reader) can be used.

The Door (Relay #1, Relay #3) will open for 3 seconds with the LED on. (LED8, LED10)

Alarms

When an unregistered card is read, the access is denied and the alarm (Relay #2, Relay #4) will be

activated for 3 seconds with the LED on (LED9, LED11) along with a buzzer sound.

When you operate the iTDC first time or you initialise the iTDC, the controller will set-up all values defaults

(factory settings). You can change the settings for desired application.

Please refer to the APPENDIX for the default setting values.

101-001 (iTDC), 101-002 (EIO88), 101-145 (iTDCSR)

-37-

Users Manual

Table of Contents