Wiring; Power; Output Connections; Communication - IDTECK Star FINGER006 User Manual

8.3 Wiring

8.3.1 Power

- Connect the (+) wire of DC 12V power to the +12V port (Red).
- Connect the GND (-) wire of DC 12V power to the GND port (Black).

8.3.2 Output Connections

Wiegand Data Connection
- Connect Data 0 wire of the controller to Wiegand Data 0 Out wire (Orange with White
Stripe).
- Connect Data 1 wire of the controller to Wiegand Data 1 Out Wire (Brown with White
Stripe).
- If you disconnect the power from the controller, connect the GND port between controllers.
Control Signal Connection
- Connect Error input wire of the controller to Error Signal Out wire (Blue with Red Stripe).
- Connect Ok input wire of the controller to OK Signal Out wire (Green with Red Stripe).
- Connect Error output wire of the controller to Error Signal In wire (Green with White stripe).
- Connect Ok wire output of the controller to OK Signal In wire (Green).
- Connect Tamper input wire of the controller to Tamper Switch Out wire (Yellow with White
stripe).
External Reader Connection
[Wiegand Input]
- Connect Data 0 wire of the external reader to Wiegand Data 0 In (EX) wire (Pink).
- Connect Data1 wire of the external reader to Wiegand Data 1 In (EX) wire (Cyan).
- If you disconnect the power from the external reader, connect the GND port between
external readers.

9. Communication

9.1 RS232 Communication Port Connection

A 9-pin connector (Serial communication connector, female) is required to connect
the FINGER006 to a host computer via RS232 communication. Please follow the instructions.
- Connect RS232-TX port of FINGER006 to the pin 2 of the 9-pin connector.
- Connect RS232-RX port of FINGER006 to the pin 3 of the 9-pin connector.
- Connect RS232-GND of FINGER006 to the pin 5 of the 9-pin connector.
Plug in the 9-pin connector to COM1 or COM2 Port of the host PC.
Install and run FINGER006 Application Software.
19