Events Sent As Indications To Smi-S Clients - Dell EMC ME4084 Owner's Manual

Hide thumbs Also See for ME4084:
Table of Contents

Advertisement

Number
Severity
Info.
Resolved
621
Info.
622
Info.
623
Info.
628
Error

Events sent as indications to SMI-S clients

If the storage system's SMI-S interface is enabled, the system will send events as indications to SMI-S clients so that SMI-S clients can
monitor system performance. For information about enabling the SMI-S interface, see the chapter about configuring the system in your
product's Storage Management Guide.
The event categories below pertain to FRU assemblies and certain FRU components.
FRU/Event
Corresponding SMI-S class
category
Controller
DHS_Controller
Hard Disk Drive
DHS_DiskDrive
Fan
DHS_PSUFan
Power Supply
DHS_PSU
Temperature Sensor
DHS_OverallTempSensor
Battery/SuperCap
DHS_SuperCap
Description/Recommended actions
Load a valid firmware bundle to disable zoning.
The controller has been injected with a fault to introduce a broadcast receiver (BR) link error.
Recommended actions:
No action is required.
Expander zoning has been disabled for the indicated enclosure.
Recommended actions:
No action is required.
A degraded ADAPT disk group rebalance operation has started.
Recommended actions:
No action is required.
A degraded ADAPT disk group rebalance operation has completed.
Recommended actions:
No action is required.
Management Controller configuration parameters were set.
One or more configuration parameters associated with the Management Controller (MC) have been
changed, such as configuration for SNMP, SMI-S (not supported on the ME4084), email notification, and
system strings (system name, system location, etc.).
Recommended actions:
No action is required.
A firmware mismatch has been identified for the expansion enclosure.
Recommended actions:
Update the firmware on the IOM with the lower revision firmware to match the firmware revision on the
other IOM.
Update the firmware on both IOMs with the latest firmware from Dell.com/support.
Operation status values that would trigger alert conditions
Down, Not Installed, OK
Unknown, Missing, Error, Degraded, OK
Error, Stopped, OK
Unknown, Error, Other, Stressed, Degraded, OK
Unknown, Error, Other, Non-Recoverable Error,
Degraded, OK
Unknown, Error, OK
Events and event messages
133

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Me4024Powervault me4 series

Table of Contents