Dell EMC ME4084 Owner's Manual page 85

Number Severity Description/Recommended actions
216 Info. An uncommitted snapshot has been deleted. Removal of the indicated snapshot completed successfully.
Recommended actions:
•
217 Error A supercapacitor failure occurred in the controller.
Recommended actions:
•
218 Warning The supercapacitor pack is near end of life.
Recommended actions:
•
219 Info. Utility priority has been changed by a user.
Recommended actions:
•
220 Info. A roll back was started. Roll back of data in the indicated volume to data in the indicated snapshot has been
started by a user.
Recommended actions:
•
221 Info. Reset of a snapshot completed successfully
Recommended actions:
•
222 Info. Snap-pool policy was set. The policy for the snap pool has been changed by a user. A policy specifies the
action for the system to automatically take when the snap pool reaches the associated threshold level.
Recommended actions:
•
223 Info. Snap-pool threshold levels were set. The threshold level for the snap pool has been changed by a user. Each
snap pool has three threshold levels that notify you when the snap pool is reaching decreasing capacity. Each
threshold level has an associated policy that specifies system behavior when the threshold is reached.
Recommended actions:
•
224 Info. A roll back completed successfully. Roll back of data in the indicated volume to data in the indicated snapshot
has completed.
Recommended actions:
•
225 Error A copy-on-write failure occurred when copying data from a master volume to a snapshot. Due to a problem
accessing the snap pool, the write operation could not be completed to the disk. Data is left in cache.
Recommended actions:
•
226 Error A roll back was not started because the snap pool could not be initialized. The roll back is in a suspended
state.
Recommended actions:
•
No action is required.
Replace the controller module that logged this event.
Replace the controller module reporting this event.
No action is required.
No action is required.
No action is required.
No action is required.
No action is required.
No action is required.
Delete all snapshots for the master volume and then convert the master volume to a standard volume.
Make sure the snap pool and the pool on which this volume exists are online. Restart the roll-back
operation.
Events and event messages 85