Dell EMC ME4084 Owner's Manual page 127

Number Severity Description/Recommended actions
Recommended actions:
•
•
•
Info. The replication direction for a replication set was reversed. Secondary is now primary. Primary is now
secondary.
During the Failback Restore operation, the replication direction for a replication set was reversed.
Recommended actions:
•
584 Info. A peer connection was modified.
Recommended actions:
•
585 Info. A replication set was modified.
Recommended actions:
•
586 Error Resuming the replication was unsuccessful due to the condition specified within the event. Reasons for
replication failure include but are not limited to shutdown of the secondary system, a loss of communication
across the peer connection (which may be due to CHAP configuration changes), or a pool out-of-space
condition.
Recommended actions:
•
Info. A replication was resumed.
Recommended actions:
•
587 Info. A pending replication was removed from the queue.
Recommended actions:
•
588 Info. A replication set was failed over.
During the Failback Restore operation, a replication set was failed over
Recommended actions:
•
589 Info. A replication set completed the Failback No Restore operation or failed to complete the Failback
No Restore operation.
Recommended actions:
•
590 Error A disk group has been quarantined.
This condition resulted from a controller flush/restore failure.
Recommended actions:
•
If an issue with the peer connection was reported, check that appropriate interface cables are connected
to the host ports defined in the peer connection.
If the appropriate cables are connected, check the cables and any network switches for problems.
Otherwise, check the peer connection for invalid configuration.
No action is required.
No action is required.
No action is required.
Resolve the issue specified by the error message included with this event.
No action is required.
No action is required.
No action is required.
No action is required.
To restore the disk group, use the CLI dequarantine command to dequarantine the disk group. If more
than one disk group is quarantined you must individually dequarantine each disk group, whether it is fault
tolerant or not. When dequarantine is complete, the disk group will return to the state it was in before
Events and event messages 127