For Linear Profile Checking - Renishaw NC1 Programming Manual

Cutter radius and linear profile checking
Example R18=10. R24=5. R02=3. R03=4. R09=0.3 R11=1.
R05=1. R06=1. R13=1 R14=2. R17=90. R19=4000.
R25=5. R26=50.
L9865

For linear profile checking

R24=x [R02=b R03=c R09=f R11=h R06=k R13=m
R14=t R17=q R19=s R25=y R26=z]
L9865
where [ ] denotes optional inputs
Example R24=5. R02=1. R03=4. R09=0.3 R11=.5 R06=1.
R13=1 R14=2. R17=90. R19=4000. R25=5. R26=50.
L9865
Subroutine inputs
R02=1. Check the cutter profile along the negative (–) tolerance
profile limit (see the figures on page 71).
R02=2. Check the cutter profile along the positive (+) tolerance
profile limit (see the figures on page 71).
R02=3. Combine both R02=1. and R02=2. profile checking in
one operation. This is the default if the R02= input is
not used.
R02=4. These are the same as the R02=1., R02=2., and
R02=5. R02=3. inputs respectively, except that the tool does
R02=6. not retract first. These cycles are suitable for performing
secondary profile checks on the same tool.
72