Renishaw NC1 Programming Manual page 43

Outputs
The following outputs are set or updated when this cycle is executed:
Set tool length
RENC[48] Out of tolerance flag. This is set when the measured
tool length is out of tolerance, provided the R11=h input
is used.
(1 = Out of tolerance, 0 = In tolerance)
Alarms
The following alarms may be generated when this cycle is executed.
FORMAT ERROR
OUT OF TOLERANCE
RPM OUT OF RANGE
For an explanation of the meaning of alarms, see "Error messages
and alarms" on page 85.
Examples
Tool length setting – on-centre tool
%_N_????
T1
M6
D1
L9800
R02=1. Set tool offset (1) on centre
Tool length setting
41