mechanical layout of the machine. Therefore, it is the responsibility of
the person putting the software into operation to:
ensure that all machine safety guards are in position and are
n
correctly working before commencement of operation;
ensure that any manual overrides are disabled before
n
commencement of operation;
verify that the program steps invoked by this software are
n
compatible with the controller for which they are intended;
ensure that any moves which the machine will be instructed to
n
make under program control would not cause the machine to
inflict damage upon itself or upon any person in the vicinity;
be thoroughly familiar with the machine tool and its controller and
n
know the location of all emergency stop switches.
Related publications
When using the Beam alignment cycle (subroutine L9860) you will
also need to refer to the following Renishaw publication. This contains
instructions on how to physically align the beam at the NC1
transmitter unit.
NC1 Installation Guide and Parts List
(Renishaw Part No. H-2000-5048)
Cautions
3