Setting-Data Subroutine L9760 - Renishaw NC1 Programming Manual

RENT[24] Position along the beam at which measurements are
made.
RENT[26] Spindle (length-measuring) axis temperature
compensation zero offset.
RENT[27] Radial-measuring axis temperature compensation zero
offset.

Setting-data subroutine L9760

Read the following parameter descriptions then edit subroutine L9760
as described.
RENC[5] False trigger retries.
If probe status checking is deactivated (see RENT[5]
parameter), the software defaults to one (1) retry.
Default: 1
RENC[6] Safe return position (in 'machine' co-ordinates).
RENC[7] The unit used for setting data in subroutine L9760.
1 = mm, 0.04 = inch
Default: 1 (mm)
RENC[9] Setting for tool offset type, either radius or diameter.
1 = Radius, 2 = Diameter
Default: 1
RENC[10] Maximum length of the tool. This defines the rapid
approach height of the spindle nose above the laser
beam.
Parameter store for calibration data
13