Broken Tool Detection (Radial Check) - Renishaw NC1 Programming Manual

Broken tool detection (radial check)

The cycle rapids the tool to the measuring height at a depth defined
by the broken tool tolerance value (R11=h input) The tool then moves
in rapid through the beam and is monitored for a broken tool
condition, i.e. the beam is not cut. The radial distance moved by the
tool from the beam centre-line is defined by the R25=y input.
At the end of the cycle, the tool moves out of the beam to the safe
position in the spindle axis only.
CAUTION
!
1. The latch mode feature of the NC1 system must be
installed and operational if the R25=y input is to be used when
passing the tool through the beam.
2. Before this cycle is called, the tool must be moved to a safe, clear
position in the Z, X, and Y axes. Ensure that the position along the
beam axis to which the tool is moved is safe for radial checking.
Format
[R11=h R13=m R19=s R25=y R26=z]
L9864
where [ ] denotes optional inputs
Example R11=5. R13=1. R19=2800 R25=3. R26=6.
L9864
66