Renishaw NC1 Programming Manual page 78

Cutter radius and linear profile checking
Outputs
NOTE: When the R02=3. or R02=6. input is used and the tool is
found to be out of tolerance during the negative (–) tolerance profile
check, the cycle is automatically aborted and does not complete the
positive (+) tolerance profile check.
RENC[48]=0 The profile is in tolerance
RENC[48]=1 The profile is out of tolerance during negative (–)
tolerance profile checking
RENC[48]=2 The profile is out of tolerance during positive (+)
tolerance profile checking
Alarms
The following alarms may be generated when this cycle is executed.
FORMAT ERROR
RPM OUT OF RANGE
RUN-OUT/EDGE MISSING
TOOL OUT OF RANGE
For an explanation of the meaning of alarms, see "Error messages
and alarms" on page 85.
76