Editing Subroutine L9760; Sample Of Subroutine L9760 - Renishaw NC1 Programming Manual

Setting-data subroutine
RENT[28] M code number to disable the latch mode. If the latch
mode feature is not to be used, enter 9 to select M9
coolant off (or similar).
RENT[29] M code number to enable the latch mode. If the latch
mode feature is not to be used, enter 9 to select M9
coolant off (or similar).

Editing subroutine L9760

Before running the cycles, edit the settings data between block
numbers LN1 and LN2 .
First, enter the metric/inch units factor (1. or .04) in parameter
RENC[7]. Next, enter data in the other parameters using the same
units.

Sample of subroutine L9760

LN1:
RENC[5]=1; RETRIES
RENC[6]=-1.; SAFE RETURN POSITION
RENC[7]=1; UNITS FOR DATA 1MM .04INCH
RENC[9]=1; OFFSET-RADIUS 1/DIAMETER 2
RENC[10]=200.; MAX TOOL LENGTH
RENC[11]=70.; MIN TOOL LENGTH
RENC[12]=80.; MAX CUTTER DIAMETER
RENC[13]=2; TL SET RADIUS MEAS DIR
RENC[14]=2; CALIB RADIUS MEAS DIR
RENC[15]=.10; NC1-DELAY IN SECS
RENC[17]=5.; DEFAULT OVERTRAVEL
RENC[18]=.002; MEASURE RESOLUTION
18
(8.0 in)
(2.75 in)
(3.15 in)
(0.197 in)
(0.0001 in)