Renishaw NC1 Programming Manual page 59

R03=c c= The number of teeth on the tool. This automatically
selects the cutting edge check.
Default value: No default.
R06=k k= The tolerance value that defines when the tool cutting
edge runout is excessive.
Default value: 0.025 mm (0.0098 in)
R09=f f= Feedrate-per-rev. for cylinder profile checking when
using the R24=x input.
Default value: 0.1 mm (0.0394 in)
R13=1. Tool out of tolerance flag.
Using this flag prevents a tool OUT OF TOLERANCE
alarm from being raised.
R17=q q= Overtravel distance and radial clearance.
For details, see "Setting-data subroutine L9760" on
page 13.
Default value: 5.0 mm (0.197 in)
R18=r r= Nominal diameter of the tool.
Default value: Maximum diameter of tool in
RENC[12].
R19=s s= Spindle speed at which radius/diameter measurement
takes place. For details, see "Setting-data subroutine
L9760" on page 13.
The spindle speed for cutting edge checking is set
automatically and is based on the minimum pulse
Cutting edge checking
57