Stylus Level Setting - Renishaw OTS Installation Manual

Stylus level setting

The top surface of disc and square styli must be
set level, front to back and side to side.
Side to side level adjustment
3.7
1
2.5 mm AF
1.1 Nm
(0.81 lbf.ft)
Probe
module
Side to side level adjustment is obtained by
alternately adjusting grubscrews, which causes
the probe module to rotate and change the stylus
level setting.
When a level stylus surface is obtained, tighten
the grubscrews.
www.armata-cnc.ru info@armata-cnc.ru +7(495)797-78-97