Installing The Touch Unit On A Whiteboard; Install Infrared Deflectors Along Any Obstacles - Epson ELPMB62 Installation Manual

Installing the touch unit on a whiteboard

Follow the steps below to install the touch unit on a whiteboard. Some menus may differ slightly from the
illustrations, but the installation instructions are the same.
❏
There are magnets built in to the back of the touch unit. Typically, the touch unit
should be installed by attaching the magnets to the screen or whiteboard.
❏
If the touch unit cannot be attached with the magnets, use commercially available
M4 screws (×2).
❏
Install the touch unit on a flat, smooth, unwarped surface. If there is unevenness
on the screen surface of more than 0.2 inch (5 mm) in any direction, your fingers
may not be detected and finger touch operations may not be performed correctly.
A

Install infrared deflectors along any obstacles

If there is an obstacle that cannot be removed, such as a whiteboard tray or thick frame, remove the
tape from the back of the supplied infrared deflectors and stick them to the screen so that the laser is
not reflected by the obstacle.
Make sure to use as many deflectors as necessary to match the full width of the obstacle.
❏
Do not remove an infrared deflector once it has been stuck in place.
❏
Do not stick tape on or place anything on the infrared deflectors. The deflectors
will not function properly if anything is placed on them.
56