Epson ELPMB62 Installation Manual page 23

6. Determine the aspect ratio of the board or of the images that will be projected. You
may need to consult your IT department for this information.
___ 4:3 XGA ___ 16:10 WXGA/WUXGA ___ 16:9 Widescreen ___ 16:6* ___ 21:9
*BrightLink 1485Fi/1485Fi+ only.
If your desired aspect ratio does not match the native aspect ratio of your product,
use the Throw Distance Calculator at www.epson.com/support (U.S.),
www.epson.ca/support (Canada), or www.epson.com.jm (Latin America) to
determine the correct measurements.
7. Using the tables on pages 30 to 32 and your desired image height (h), find the required
distance between the top of the image area and the bottom holes of the wall plate (c). _____ (c)
8. Using the tables on pages 30 to 32 and your desired image height (h), find the required
distance between the top of the image area and the temporary wall plate hole (d).
9. Determine the position for your projector installation by adding the values for (f), (h),
and (c), plus an additional 10 inches for the height of the wall plate plus the cover.
If the ceiling height of your room (as noted in step 1) does not meet the minimum
ceiling height required for your board, you may need to select a smaller image size or
move the board to a lower position on the wall.
10. After confirming your image size, use tape or a pencil to mark the distance (c) from the
top of the image area on the board to the bottom holes of the wall plate.
11. Align the line (horizontal) on the template sheet with the (c) mark, then align the
center line on the template sheet with the center of the image area. Follow the
instructions on page 33 to install the projector.
23
_____ (d)
_____ (f )
_____ (h)
_____ (c)
+ 11 inches
_____ total