Drill Holes For The Bracket; Install The Bracket - Epson ELPMB62 Installation Manual

E

Drill holes for the bracket

If possible, drill holes at the four points labeled Main on the template sheet.
If you're unable to use the points labeled Main, you can secure the bracket at the points labeled Sub.
Make sure you secure the bracket at four points (two on the left and two on the right)
for proper balance.
F

Install the bracket

1. Loosen the screws (×2) at the top of the bracket.
2. Slide the front of the bracket forward until it is fully extended.
To prevent the front of the bracket from slipping during installation, loosely tighten the top screws.
3. Secure the bracket on the wall using four (×4) 3.8 mm wood screws that are 46 mm long or four (×4) M4
anchor bolts (not included).
71