Epson ELPMB62 Installation Manual page 39

3. Insert the hexagonal shaft into the slot at the top of the wall plate (
4. Insert the hexagonal shaft into the slot at the bottom of the wall plate (
Caution
❏
Make sure the Touch Unit connection cable is not wired into the wall with the other cables.
❏
Take care not to trap the cables between the mount arm and wall plate.
5. Secure the mount arm to the wall plate by tightening the supplied M6 × 20 mm cross recessed head
shoulder screws (×3) with the #3 cross-head screwdriver.
Make sure you use the included plastic washers. If you don't use the plastic washers,
you may damage the M8 hexagon bolt as you adjust the vertical slide position.
).
39
).