Distance From Top Of Projected Image To Wall Plate; Installation Measurement Tables - Epson ELPMB62 Installation Manual

Distance from top of projected image to wall plate

The distance (c) from the top of the projected image to the bottom mounting holes on the wall plate is the
number given when the vertical slide is set to the base position, as shown below.
Match the notch on the wall mount to the position of the stamp on the wall plate.

Installation measurement tables

Use the following installation measurement tables for your projector.
The measurements may differ depending on the location where you place the
projector. When projecting in Tele mode, the quality of the projected images may
decrease.
When projecting in the 16:6 or 21:9 aspect ratio, the projected image has black bars
above and below it by default. You can use the Screen Position setting to move the
projected image to the top of the screen and the black bars below the image. Note that
the distance from the top of the image to the bottom wall plate holes (c) or temporary
wall plate hole (d) will vary if you change the Screen Position setting. The distance
tables for the 16:6 and 21:9 aspect ratios include measurements for both the default
Screen Position setting and measurements for an image that has been adjusted to sit
at the top of the projection screen.
27