Table of Contents
Advertisement
Message
Reason
Error receiving host\nlist
Bad Protocol detected.
from Server;
Unexpected Server\ndata
Bad Protocol detected.
received;
Error starting\nhost
Connected to the server but can not connect
application;
to the distant end.
Select Host or App;
Need to choose your Host/application
destination.
Connecting...;
Attempting to connect to the Host/application. Advisory message.
TCP Error\nReading IP
Mobile Unit missing Network IP information.
Address\nREBOOT MOBILE
UNIT;
Printer start error;
Could not initialize the printer.
Battery too low\nto print;
Not enough power to print.
Paper Feed Error\nFix Then
Paper in the printer is not ready.
Hit Enter;
Printer Error\nPrint Ended;
Can not print.
•
Supported Equipment Manual
May, 2006
Solution
Usually a result of bad cabling, power or
faulty transceiver. Also, will receive this if
the Mobile Unit is in the wrong mode for
Server operation.
Usually a result of bad cabling, power or
faulty transceiver. Also, will receive this if
the Mobile Unit is in the wrong mode for
Server operation.
Configure the server handler to access the
host application.
User selection required.
Configure the Mobile Unit with the correct
network IP information.
Cable or power issue with the printer.
Replace the battery with a fully recharged
battery.
Replace the paper or rethread the paper in
the printer.
Check cable, battery, communication
settings and paper in the printer.
Error Message Resolution Guide
Reference Tech Note
---
---
---
---
---
---
---
---
---
---
4-5
Advertisement
Table of Contents
