Table of Contents
Advertisement
Message
Reason
Printer Not Ready\nPress R
Can not print.
to Retry\nC to Cancel Print;
Mobile Unit
Running in demo mode.
in\nDemonstration
Mode\nfor TwinClient;
Connected to Host;
Successful connection to the target Host.
Telnet Mode not\nsupported
This Mobile Unit must be used with a Connect
on\nthis Mobile Unit;
Server.
Telnet Setup files\nnot
Customer specific configuration files are
found. Reload\nfiles then
missing.
switch;
Switched Client to\nTelnet
Mobile Unit running in Telnet mode direct to
Direct Mode;
the target Host.
Switched Client to\nServer
Mobile Unit running through a Connect server
Based Mode;
in Server mode usually at port 1800.
Port 23 is only\nallowed in
Can not set the port to 23 in Server mode.
Telnet Mode;
Port 23 is the standard Telnet port.
Not Enough Memory\nTo
Mobile Unit does not have the capacity to run
Run;
the program do to memory restrictions.
Press any key;
Press a key to continue.
TwinClient Telnet;
Prompt.
•
Supported Equipment Manual
May, 2006
Solution
Check cable, battery, communication
settings and paper in the printer.
Purchase a license from Connect.
Advisory message.
Order a Connect Server.
Load the configuration files into the Mobile
Unit from Twin Client Manager.
Advisory message.
Advisory message.
Advisory message.
Expand the Mobile Unit memory.
Advisory message.
Advisory message.
Error Message Resolution Guide
Reference Tech Note
---
---
---
---
---
---
---
---
---
---
---
4-7
Advertisement
Table of Contents
