Denso BHT-200 Supported Equipment Manual page 42

Terminal Setup
RF Monitor is a very small program and does not even require installation. Just place it in
a directory on your PC and create a shortcut to run it. It will run on all versions of
Windows except V3.1 and Windows 95.
1. Move RF Monitor to a Windows PC with Network access to the RF terminal.
2. Run RF Monitor. (Create a shortcut or do a
From the pull down menu, select
3.
4. Key in the RF terminal IP address and leave the port at 1802.
5. From the pull down menu, select
Data stream and SNA.
2-36
.)
Start/Run
File/Select Terminal.
Tools/Set Debug Levels.
Supported Equipment Manual
Set all levels to 9 except
•
May, 2006