Starting a Telnet Session
At the Twin Client main menu on the terminal, press any key to establish the connection.
Until the terminal has been authorized, the following screen is displayed.
RECOVERABLE ERROR
Terminal not
Authorized for
Twin Client
Keypress to continue...
It is not necessary to authorize the terminal at this time, so press any key to continue. The
terminal will establish a connection with the host system and start emulation.
After a Telnet session has been successfully established, the terminal will remain in
session for a maximum of 30 minutes at a time until it has been authorized. Once
authorized, there is no software restriction to the session time. The instructions for
authorizing the terminal are presented in Authorizing PowerNet.
Standard Setup
The default terminal setup is sufficient for most installations. However, to meet site-
specific requirements, it may be necessary to customize terminal operation. The standard
setup options simplify this process and can be modified by the following methods:
•
Using the Twin Client Manager.
•
Using the Twin Client terminal menu system.
This section describes how to use the Twin Client Manager and the terminal menu system
to set up the terminal. Also described are the methods for authorizing the terminal
software.
Setup Using Twin Client Manager
The Twin Client Manager provides a
terminals. The options within this tab vary according to the emulation selected, each of
which is described below. Click on
VT Settings
Select the VT emulation setup by clicking on the
menu, as shown below.
Supported Equipment Manual
Standard
•
May, 2006
tab for automatic setup of the
Standard Settings
under the
View
menu and then the
Settings
Standard Setup
option in the main menu.
Emulation
2-13