Booting The Terminal - Denso BHT-200 Supported Equipment Manual

Check the
addresses, software, and configuration files to the terminals. Click on the
upper right corner to return to the main menu.
The software does not need to be authorized now. It can be authorized later, after a
Note:

Booting the Terminal

At any time it is necessary to update the terminal software and/or configuration, the
terminal must be cold-booted. Instructions on performing a cold boot (also known as a
hard reset) and on performing a warm boot (also known as a soft reset) are as follows.
Warm boot:
Cold boot:
Supported Equipment Manual
box, and the system is now configured to automatically download IP
Active
Telnet session has been established. The procedure is described in the section of
this chapter entitled Authorizing PowerNet.
Press the button on the side of the terminal.
Reset
Press the button while holding the
Reset
•
May, 2006
box in the
key.
Power
Quick Start
2-11