Authorizing Powernet - Denso BHT-200 Supported Equipment Manual

Hide thumbs

Table Of Contents

Table of Contents

Terminal Setup

Host 0

IP 206.183.67.155

Port 23__

<F3> Save <F7> Quit

Press

Edit License Key

The client software can be authorized automatically, as described in the next section,

Authorizing PowerNet. This menu option permits authorization of each terminal

manually. Select this option to obtain the terminal's Identification Code, which is used to

obtain the Authorization code from the Connect web site, as described in the next section.

The 12-digit value at the top of the terminal screen is the terminal's Identification Code.

00A0F826E614

Authorization

______________

not authorized

<F3> Save <F7> Quit

Type the Authorization code into the field as it appears on the web site. Punctuation

characters, such as the hyphen (-), are required. Press

Run Site Survey

This option (a feature of Spectrum 1) is applicable to Release 5.0 and may be obsolete for

your terminal.

Switch Client Modes

The PowerNet Twin Client normally operates in Telnet mode, which provides direct

connection to Telnet hosts. It can also operate in Server mode, through a PowerNet

OpenAir server. Select this menu option to switch between Server and Telnet modes of

operation. Note that the host socket address for the PowerNet OpenAir servers is 1800,

which must also be changed in the

Run Client Emulator

After all desired changes have been made, select this option to return to the Twin Client

main menu. Then press any key to establish the Telnet session and begin emulation.

Refer to the Starting a Telnet Session section for further instructions.