Quick Start; Configuring The Manager - Denso BHT-200 Supported Equipment Manual

Quick Start

This section describes how to prepare the Twin Client Manager and the Denso terminal
for a Telnet session with the host. Following an initial serial download, the terminal
software and configuration are managed automatically over the wireless network.
Denso terminals are normally delivered with Denso files pre-installed. However, if
Note:

Configuring the Manager

The first step is to configure the Twin Client Manager to meet site-specific requirements,
and then prepare it for the automatic management of the terminal software and IP
addresses. This simple procedure will require only a few minutes to complete.
Setting the Emulation
Click on
menu, as shown below.
Click on
Setting the Servers
The Servers are the Telnet host systems the terminals will access.
Supported Equipment Manual
the terminal does not have those files installed refer to the section entitled
Configuring the BHT-200 Terminal for Download before proceeding.
, ,
Start Programs PowerNet
, select the desired emulation, and click on
Emulation
•
May, 2006
, and
Twin Client Manager
Quick Start
. Select the
Settings
.
OK
2-5