Table of Contents
Advertisement
Standard Setup
Key Click
This check box enables (checked) or disables (unchecked) audible key clicks from the
terminal. The default value is
(checked).
on
Printer Type
This scrolling list selects the attached printer type. The default value is
indicating
none,
that no printer is attached.
Terminal Setup Using Twin Client Menus
The Twin Client terminal software provides an internal menu system for configuring
certain parameters on the terminal and for switching between Server and Telnet modes of
operation. To access this menu system, press uppercase
at the startup screen as shown
C
in the following figure.
Twin Client
© 1991-2006, Connect, Inc.
Keypress to continue
The date of 2006 is updated on the terminal at the time of a new release.
Note:
The following menu appears in thick (Telnet) mode:
Edit Server/Host IPs
Edit License Key
Switch Client Modes
Run Client Emulator
Exit to OS
The following menu appears in thin (Server) mode:
Edit Server/Host IPs
Run Site Survey
Switch Client Modes
Run Client Emulator
Exit to OS
Use the
and
keys to navigate the menu, and press
to select
Up-Arrow
Down-Arrow
Enter
the highlighted option. Each menu option is described below.
Edit Server/Host IPs
If the host IP address(es) were not pre-configured as described in the Setting the Servers
section of Configuring the Manager, or if you wish to change those settings using the
terminal menus, select this option and enter up to four Host IP addresses as required.
•
2-19
Supported Equipment Manual
May, 2006
Advertisement
Table of Contents
