Denso BHT-200 Supported Equipment Manual page 60

Error Message Resolution Guide
Message Reason
User Count Exceeded.\n Possible authorization issue.
Session Ended;
Primary Unavailable\nTrying First Host IP address not available trying the
Alternate; remaining addresses in the Host list.
APMAC.DAT Error\nSession Access point Media Access Control error.
Ended;
MUIP.DAT Error\nSession Mobile Unit IP Error.
Ended;
Missing Subnet IP\nSession Mobile Unit IP Netmask Error.
Ended;
Error Opening File; File is missing.
Telnet API\nnot found; Program files are missing.
Battery Low Not enough power to operate the Mobile Unit. Replace the battery with a fully recharged
Warning\n\nReplace Battery
Soon;
No Host List.\nPress any Have not configured your target hosts.
key\nTo Edit Host IP's;
Unable to Allocate\nFont Mobile Unit does not have enough memory to
Memory; load the fonts.
Font Loading Error; Could not load the font.
4-6
Solution
Verify that you have the correct number of
licenses for the number of Mobile Units you
are using.
Verify that the host address.
Most likely a range, access point, radio,
host or network issue. Troubleshoot the
customer's environment.
Most likely a Mobile Unit network setting
issue. Troubleshoot the customer's
environment.
Most likely a Mobile Unit network setting
issue. Troubleshoot the customer's
environment.
Verify that the configuration files are on the
Mobile Unit. Or perhaps there is a
hardware failure.
Reload program files.
battery.
Configure the target host IP addresses.
Reduce the fonts in use or expand the
memory in the Mobile Unit.
Ensure that the font is available to load.
Supported Equipment Manual
Reference Tech Note
---
---
T1113, T1114, T1161,
T1171, T1187 and
T1194
T1113, T1114, T1161,
T1171, T1187 and
T1194
T1113, T1114, T1161,
T1171, T1187 and
T1194
---
---
---
---
---
---
• May, 2006