Terminal Setup
To set these addresses from the
Then click on
for Telnet servers), and terminal type. Then click on
Repeat this step for each Telnet server the terminals are required to access. If an error is
made in the name, IP address, IP port number, or terminal emulation type, click on the
line that is in error and then click on the
button if you want to load an .svr file. Use the
Load
your file as an .svr file.
2-6
Settings
. Enter the name of the server, its IP address and IP port (normally 23
Add
menu, click on
Servers.
.
OK
button to make the corrections. Use the
Edit
button if you want to save
Save As
Supported Equipment Manual
•
May, 2006