Denso BHT-200 Supported Equipment Manual page 15

Quick Start
Setting Airloader Auto-Configuration
The configuration download and IP address assignment for each terminal will take place
automatically by setting the Airloader Auto-Configuration options.
Click on the option in the menu.
Airloader Tools
If the Airloader Auto-Configuration window does not display the options, click on
Note:
the button.
Advanced<<
If multiple network adapters are installed on the PC, ensure that the desired network
adapter is selected. The adapter selection can be changed by clicking on the
Change
button.
This powerful software management tool is described in detail in the section entitled
Airloader Auto-Configuration. For now, it is sufficient simply to use it for assignment of
the initial terminal configuration and IP address, both of which can be easily changed
later. Ensure that all of the check boxes are checked as shown above.
To assign terminal IP addresses automatically over the wireless network, check all of the
boxes as shown above. Then click on the button and enter the desired range
Addresses
in the and boxes as shown in the following figure.
From To
•
2-9
Supported Equipment Manual May, 2006