Ieee Standards; Agency Compliance; Usa Federal Communications Commission Statement - Dell EMC PowerSwitch Z9332F-ON Installation Manual

Hide thumbs Also See for PowerSwitch Z9332F-ON:
Table of Contents

Advertisement

Parameter
Shock
NOTE:
AC power requires HighLine 200–240 VAC support. Using 120 VAC does not provide adequate power for the
system.
Table 7. AC power requirements
Parameter
Power supply
Maximum current draw per system
Maximum power consumption
Typical power consumption

IEEE standards

The Z9332F-ON switch complies with the following IEEE standards.
802.1ab (LLDP)
802.1ax (Layer 2)
802.1d, 802.1w, 802.1s, 802.1x (Mgmt/Security), 802.3x (Layer 2)
802.3 (1000BASE-KX)
802.3ba (40GbE and 100GbE ports)

Agency compliance

The Z9332F-ON switch is designed to comply with the following safety and agency requirements:
USA Federal Communications Commission
statement
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC rules.
These limits are designated to provide reasonable protection against harmful interference when the equipment is operated in a commercial
environment. This equipment generates, uses, and can radiate radio frequency energy. If it is not installed and used in accordance to the
instructions, it may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause
harmful interference, in which case users will be required to take whatever measures necessary to correct the interference at their own
expense.
Properly shielded and grounded cables and connectors must be used in order to meet FCC emission limits. Dell EMC is not responsible for
any radio or television interference caused by using other than recommended cables and connectors or by unauthorized changes or
modifications in the equipment. Unauthorized changes or modification could void the user's authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause
harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired
operation.
Figure 2. Canadian Department of Communication Statement
32
Specifications
Specifications
Dell EMC Spec SV0115
Specifications
200–240 VAC 50/60 Hz
8.5A@200VAC
1244.86 W maximum
1004 W typical—Measured @ 45°C, 16 ports with AOC and 16
ports with SR8 optics running snake traffic

Advertisement

Table of Contents
loading

Table of Contents