The Z9332F-ON switch provides three ports for management and one USB flash drive mount for file transfers.
NOTE:
The output examples in this section are for reference only. Your output may vary.
Topics:
•
RJ45 console port access
•
USB storage mount
RJ45 console port access
The management ports are on the I/O-side of the switch.
1. RJ45 console port (top); USB Type-A port (middle); RJ45 Ethernet port (bottom).
NOTE:
Ensure that any equipment that is attached to the serial port can support the required 115200 baud rate.
NOTE:
If the serial port on your computer cannot accept a female DB-9 connector, use a DB-9 to USB adapter.
1. Install the provided RJ45 connector-side of the provided cable into the switch console port.
2. Install the DB-9 female-side of the provided copper cable into the serial port on your computer.
Or install the DB-9 cable into other data terminal equipment (DTE) server hardware.
3. Use the following settings to make the serial port connection:
•
115200 baud rate
•
No parity
•
Eight data bits
•
One stop bit
•
No flow control
USB storage mount
USB storage does not automatically mount. USB storage supports the FAT file system. To use USB storage, first mount the device using
the following steps:
1. Start up the switch.
2. Press Enter on the ONIE rescue mode menu option from the ONIE Grub boot loader.
3. Create a mount directory for the USB storage.
ONIE:/ # mkdir /mnt/usb
4. View the fixed disks using the fdisk command.
ONIE:/mnt # fdisk -l
Management ports
Management ports
7
27