Table of Contents
Advertisement
LED display
The Z9332F-ON switch includes LED displays on the I/O side of the switch. This section describes open networking installation
environment (ONIE) LED behaviors. Some LED behaviors may change after you install your software.
LED behavior
The following Z9332F-ON switch LED behavior is seen during start up:
NOTE:
Although each port has four LEDs, only one LED indicates switch status. The other three LEDs are intentionally
off.
1. Port Activity LEDs
3. System LED
5. Power Supply LED
7. RJ45 Ethernet Port LED
NOTE:
For an ONIE-installed switch, after ONIE boots, the LED flashes 1 Hz green and yellow.
Table 2. Z9332F-ON switch LED behavior
LED
System Status/Health LED
Fan LED
Power Supply LED
2. Port Activity LEDs
4. Fan LED
6. Alarm LED
Description
•
Solid green—Normal operation
•
Flashing green—Booting
•
Solid yellow—Major alarm. For example, thermal sensor
reached the critical temperature
•
Flashing yellow—Minor alarm. For example, one PSU or fan
failed.
•
Off—No fan present
•
Solid Green—Normal operation and all fans present
•
Solid yellow—Any one fan is absent or any fan status not in a
normal status
•
Off—No power
•
Solid green—Normal operation and all PSUs are present
•
Solid yellow—One PSU is absent or any one PSU status is not
in a normal status.
The Z9332F-ON switch
9
Advertisement
Table of Contents
