Table of Contents
Advertisement
IEEE standards
The N2200-ON Series switch complies with the following IEEE standards.
•
802.3ab
•
802.1ax (Layer 2)
•
802.1d, 802.1w, 802.1s, 802.1x (Mgmt/Security), 802.3x (Layer 2)
•
802.3
•
802.3ba (40GbE and 100GbE ports)
•
802.3bt
•
802.3at
•
802.3az
•
802.1v
•
1613
•
802.1p, 1q
•
802.1s
•
802.3u, 802.3bz
Agency compliance
The N2200-ON Series switch is designed to comply with the following safety and agency requirements:
India
This product conforms to the relevant Essential Requirements of the Telecommunication Engineering Centre (TEC) regulations.
USA Federal Communications Commission statement
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC rules.
These limits are designated to provide reasonable protection against harmful interference when the equipment is operated in a commercial
environment. This equipment generates, uses, and can radiate radio frequency energy. If it is not installed and used in accordance to the
instructions, it may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause
harmful interference, in which case users will be required to take whatever measures necessary to correct the interference at their own
expense.
Properly shielded and grounded cables and connectors must be used in order to meet FCC emission limits. Dell EMC is not responsible for
any radio or television interference caused by using other than recommended cables and connectors or by unauthorized changes or
modifications in the equipment. Unauthorized changes or modification could void the user's authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause
harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired
operation.
Figure 5. Canadian Department of Communication Statement
European Union EMC directive conformance statement
This product is in conformity with the protection requirements of EU Council Directive 2004/108/EC on the approximation of the laws of
the Member States relating to electromagnetic compatibility. Dell EMC cannot accept responsibility for any failure to satisfy the protection
requirements resulting from a non-recommended modification of this product, including the fitting of non-Dell EMC option cards.
56
Specifications
Hide quick links:
Advertisement
Table of Contents
